Heath Zenith HD-9260 Bedienungsanleitung PDF herunterladen (Seite 10)

-10-

598-1188-02

Adjustments Continued . . .

Aim Sensor Down

for Short Coverage

❒ Loosen the two thumb screws. Estimate the direction to aim the sensor

and tighten the thumbscrews just enough to hold the sensor in place.

NOTE: The top screw allows the sensor to rotate side to side. The bot

tom screw allows the sensor to rotate up and down.

❒ Walk through the coverage area noting where you are when the lights

turn on (also, the LED will ﬂash several times when motion is detected).

Loosen the thumbscrews and readjust the sensor as necessary. Tighten

the thumbscrews (ﬁnger tight) when you are satisﬁed with the coverage

direction.

Keep the sensor at least 1 inch (25 mm) from lamps and

keep the controls facing downward.

❒ Adjust RANGE as needed to increase or decrease the range. Too much

sensitivity may cause false triggering in some environments.

❒ For maximum range, the sensor must be aiming straight out.

❒ Set the amount of TIME (1, 5, or 20 minutes) you want the lights to stay

on after motion is detected at night.

❒ Release the tab on metal door to allow door to close.

Aim Sensor Out for

Long Coverage

Expected Coverage

The sensor is less sensitive to motion directly

towards it, most sensitive to motion across its

ﬁeld of view.

When mounted 8 feet (2.4 m) from the ground, you

may expect the range shown below. If mounted

much higher the sensor may miss objects near the

ground. If mounted much lower the sensor range

may be reduced.

Maximum Range

(Sensor aiming straight out)

8 ft.

(2.4 m)

70 ft. (21.0 m) 100 ft. (30.5 m)

With RANGE With RANGE

Set to MAX Boosted

Sensor

Least Sensitive Most Sensitive

Motion Motion

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

Heath Zenith HD-9260 Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Arbeitsscheinwerfer Heath Zenith HD-9260